PS 2 EMULATION BOARD (B431)
B441 1-4 SM
1.3 PS 2 EMULATION BOARD (B431)
!
CAUTION
Unplug the main machine power cord before starting the following
procedure.
NOTE: To install the Postscript option, the printer option (B441) must be installed
also. Please refer to section 1.2 for the printer controller installation
procedure.
1. Remove the rear cover [A] (5 screws).
2. Remove the controller board [B] from the machine (1 harness and 8 screws or
6 screws if no fax option).
3. Connect the PS 2 emulation board [C] to CN505 on the controller board.
4. Replace the controller board assembly in the machine.
5. Replace the rear cover.
B441I503.WMF
B441I501.WMF
B441I505.WMF
[B]
[A]
[C]
To Next Page
Loading...
