DOCUMENT FEEDER
B044/B045/B046 1-20 SM
8. Install the DF connection board [A] and DF board bracket [B]. (! x 5)
9. Connect the four wire sets from the DF body to CN103, CN105, CN106, and
CN107 on the DF connection board. (Not shown in illustration.)
10. Connect one end of the supplied wire harness [C] to CN101 and CN102 on the
DF connection board, and connect the other end to connectors CN9 and CN10
on the FCU. Secure the wire harness into the clamp [D] located to the side of
the DF board.
11. Reattach the rear cover and the platen cover.
12. Plug in the power cord, and turn on the main switch.
13. Make a full-size copy from the first tray using the ADF, and check the side-to-
side and leading edge registrations. If the registration is incorrect, adjust as
necessary (☛ 3.13.3).
B046I513.WMF
[A]
B
[C]
[D]
To Next Page
Loading...
