Ricoh aficio 1013F - Hot Roller & Fusing Lamp; Thermofuse, Thermoswitch, and Thermistor

FUSING
SM 3-15 B044/B045/B046
Replacement
and
Adjustment
3.5.4 HOT ROLLER & FUSING LAMP
1. Hot roller stripper pawls (☛ 3.5.3)
2. Hot roller assembly [A] (! × 2)
NOTE: 1) Each of the screws has a
washer.
2) After removing the screws,
lift the hot roller assembly
out from the rear side.
3. Fusing lamp [B]
4. Hot roller [C] (2 C-rings, 1 spacer,
1 gear, 2 bushings)
3.5.5 THERMOFUSE, THERMOSWITCH, AND THERMISTOR
1. Remove the hot roller assembly
from the hot roller section.
(☛ 3.5.3)
2. Thermofuse [A] (! × 2).
3. Thermoswitch [B] (! × 2)
NOTE: You must remove the
thermofuse first.
4. Thermistor [C] (! × 1)
B046R505.WMF
B046R509.WMF
B046R506.WMF
[A]
[B]
[C]
[B]
[A]
[B]
[C]