Ricoh aficio 1013F - 3.13 COPY IMAGE ADJUSTMENTS: PRINTING;SCANNING

COPY IMAGE ADJUSTMENTS: PRINTING/SCANNING
SM 3-33 B044/B045/B046
Replacement
and
Adjustment
3.13 COPY IMAGE ADJUSTMENTS: PRINTING/SCANNING
NOTE: 1) You need to perform these adjustment after executing a Memory All
Clear, and after replacing or adjusting any of the following parts.
• First or second scanner
• Lens Block
• Scanner Motor
• Polygon Mirror Motor
• Paper Tray
2) For detailed explanations about how to access and use SP mode, see
Section 5.
3.13.1 PRINTING
NOTE: 1) Make sure the paper is installed correctly in each paper tray before you
start these adjustments.
2) Use the Trimming Area Pattern (SP5-902, No.10) to print the test
pattern for the printing adjustments below.
3) Reset SP5-902 to 0 after completing these printing adjustments.
Registration - Leading Edge/Side-to-Side
1. Check the leading edge registration [A] for each paper feed station, and adjust
each of these registrations using SP1-001.
Tray SP mode Specification
Paper tray(s) SP1-001-1
0 ± 2 mm
100-sheet bypass
0 ± 2 mm
1-sheet bypass
SP1-001-2
0 ± 4 mm
2. Check the side-to-side registration [B] for each paper
feed station, and adjust these registrations using SP1-
002. (Adjust the trays in order: the 1st tray first, then
the 2nd tray [if installed], then the bypass).
Tray SP mode Specification
1st tray SP1-002-1
2nd tray SP1-002-2
0 ± 2 mm
100-sheet bypass
0 ± 2 mm
1-sheet bypass
SP1-002-5
0 ± 4 mm
B
A
B046R552.WMF
A: Leading Edge Registration
B: Side-to-side Registration