Delivery Procedure
45
5
Delivery Procedure
Data is delivered by specifying its scan
settings and destination. If necessary,
you can select a sender and subject.
A
Press the {Scanner} key.
B
If the user code is set, enter the
user code (consisting of up to
eight characters) with the number
keys, and then press [#].
The Scanner Function screen ap-
pears.
Note
❒ If the network TWAIN scanner
screen is displayed, press [Can-
cel]. This screen is displayed if
"Function Priority" in the Scan-
ner Initial Setup is set to net-
work TWAIN scanner mode.
C
Make sure that no previous set-
ting remains.
Note
❒ If the previous setting remains,
press the {Reset} key.
D
Place the original in the machine,
and adjust the settings for original
size and orientation if required.
Reference
⇒ p.33 “Setting Originals”
E
Make the scan settings.
To make the scan settings, call up
the stored settings or make the set-
tings individually.
Reference
⇒ p.14 “Setting Scanner Fea-
tures”
Calling up stored scan settings
A Press [Recall Program].
The User Program Recall screen
appears.
B Select a user program of scan
settings.
C Press [OK].
The selected user program set-
tings become active.
Making the settings individually
A Press [Scan Settings].
The screen for making scan set-
tings appears.
To Next Page
Loading...
