Transmission Mode
10
1
❒ You can set whether a Polling
Transmission file is deleted after
transmitting in "User Parameters."
Set this with the User Parameters.
⇒ p.141 “Changing the User Pa-
rameters”(Switch11, Bit7)
❒ A polling ID may be any string of
four numbers (0 to 9) and charac-
ters (A to F) except 0000 and FFFF.
❒ The communication fee is charged
to the receiver.
A
AA
A
Place your original, and then se-
lect any scan settings you require.
B
BB
B
Press [Transmission Mode].
The Transmission Mode menu ap-
pears.
C
CC
C
Select [
Polling TX
].
D
DD
D
Depending on the Polling Trans-
mission mode, use one of the fol-
lowing procedures:
Free Polling TX
A
AA
A Check that [Free Polling TX] is
selected.
B
BB
B If [Free Polling TX] is not select-
ed, press [Free Polling TX].
Default ID Polling TX
A
AA
A Select [
Default ID TX
].
ID Override Transmission
A
AA
A Select [ID Override Transmission].
RusC2FaxADEN-F_V4_FM.book Page 10 Monday, August 20, 2001 10:52 AM
To Next Page
Loading...
