Advanced Features
47
4
Transfer Request
Transfer Request allows fax machines
that have this feature to automatically
distribute incoming messages to mul-
tiple fax destinations. This feature
helps you save costs when you send
the same message to more than one
place in a distant area, and saves time
since many messages can be sent in a
single operation.
The diagram below may make the
concept clearer.
Preparation
Before you can use this feature,
you must program the Polling ID.
⇒ p.170 “Programming a Polling
ID”,⇒ p.167 “Transfer Report”
The following terminology is used in
this section.
❖
❖❖
❖ Requesting Party
The machine where the message
originates from (this machine).
❖
❖❖
❖ Transfer Station
The machine that forwards the in-
coming message to another desti-
nation.
❖
❖❖
❖ End Receiver
The final destination of the mes-
sage or the machine to which the
Transfer Station sends to.
Limitation
❒ The Transfer Stations you specify
must be machines of the same
make as this machine and have the
Transfer Station function.
❒ The fax number of the Requesting
Party (this machine) must be pro-
grammed into a Quick Dial or
Speed Dial in the Transfer Station.
If not, you cannot use this feature.
Note
❒ Polling ID's of the Requesting Par-
ty (this machine) and Transfer Sta-
tions must be identical.
❒ You can specify up to 100 Transfer
Stations in a Transfer Request.
However, you can only specify up
to 50 Transfer Stations from the
number keys.
❒ You can have up to 30 End Receiv-
ers per Transfer Station. If you
specify a Transfer Station Group,
the Group counts as a single re-
ceiver.
❒ The combined total of End Receiv-
ers and Transfer Stations you spec-
ify with the number keys cannot
exceed 100. ⇒Chapter 2, "Restric-
tions with Dialing with Number
Keys" in the Basic Features manual
A
AA
A
Place your original, and then se-
lect any scan settings you require.
RusC2FaxADEN-F_V4_FM.book Page 47 Monday, August 20, 2001 10:52 AM
To Next Page
Loading...
