Transmission Features
50
4
-
--
-Group of Multistep Transfer
Program a Transfer Station into
groups of this machine. By program-
ming the end receivers in the Transfer
Station Group, you can enable this ma-
chine to transfer messages to other
Transfer Stations. (The number of end
receiver destinations per one Transfer
Station should not exceed 30.) The
principles of Transfer Stations can be
used to build up a multi-step facsimile
network where messages are passed
through several Transfer Stations.
For more information, contact your
service representative.
Sub-address
The optional ISDN Unit is required.
ISDN allows two or more terminals
(such as a fax machine and digital tel-
ephone) to be connected to a single
line. These terminals are identified by
their sub-address numbers. If the ter-
minals connected to the line at a des-
tination are assigned sub-addresses,
dialing a sub-address allows you to
direct your fax message to a particu-
lar terminal at the destination.
Limitation
❒ Sub-addresses can only be used
with ISDN.
Note
❒ You can program a sub-address in
Quick Dial.
A
AA
A
Select either G4 or G3 (ISDN).
Note
❒ When the optional ISDN Unit is
installed, the line used for G3 is
set to ISDN.
Reference
⇒ p.55 “Changing the Line
Type”
B
BB
B
Dial the fax number with the
number keys.
C
CC
C
Press [Adv. Features].
D
DD
D
Select [Sub-address/UUI].
E
EE
E
Select [Sub-address].
RusC2FaxADEN-F_V4_FM.book Page 50 Monday, August 20, 2001 10:52 AM
To Next Page
Loading...
