Transmission Features
54
4
Manual Dial
The optional external telephone is required.
Pick up the handset of the optional
external telephone and dial. When
the line is connected and you hear a
high-pitched tone, press the {
{{
{Start}
}}
}
key to send your fax message. If, on
the other hand, you hear a voice at the
other end, continue your conversa-
tion as you would normally over the
telephone.
Limitation
❒ Manual Dial does not work with
ISDN lines.
❒ This feature is not available for the
optional Extra G3 Interface Unit.
❒ The result of a transmission with
manual dial is not mentioned in
the Transmission Result Report
(Immediate Transmission).
❒ When the machine has just
changed to the Economy Trans-
mission mode, there is no sound
when you pick up the handset for
4 seconds (Max). You can operate
the machine after hearing a tone.
A
AA
A
Place your original, and then se-
lect any scan settings you require.
Reference
⇒ Chapter 2, "Setting Originals"
in the Basic Features manual
⇒ Chapter 2, "Scan Settings" in
the Basic Features manual
B
BB
B
Pick up the handset of the exter-
nal telephone.
You will hear a tone.
C
CC
C
Dial.
The machine immediately dials the
destination.
Note
❒ If you make a mistake, replace
the external telephone and try
again from step
B
.
D
DD
D
When the line is connected and
you hear a high-pitched tone,
press the {
{{
{Start}
}}
} key to send your
fax message.
Note
❒ If you hear a voice, notify the
destination that you want to
send a fax message (ask them to
switch to Facsimile mode).
E
EE
E
Replace the handset of the exter-
nal telephone.
After transmission, the machine
will return to standby mode.
To stop transmission, press the
{
{{
{Clear/Stop}
}}
} key and remove origi-
nals.
RusC2FaxADEN-F_V4_FM.book Page 54 Monday, August 20, 2001 10:52 AM
To Next Page
Loading...
