Copying from the Bypass Tray
31
2
Important
❒ If the guides are not flush
against the copy paper, a
skewed image or paper mis-
feeds might occur.
❒ The copy side of OHP transpar-
encies is fixed. When you load
them in the bypass tray, check
the cutting position of the OHP
transparencies, and then place
them correctly, or a misfeed
might occur.
Note
❒ Place copy paper in the orienta-
tion of L.
❒ Swing out the extender to sup-
port paper sizes larger than
A4L, 8
1
/
2
" × 11"L.
❒ Fan paper to get air between the
sheets and avoid a multi-sheet
feed.
D
DD
D
Push down the paper guide re-
lease lever.
“ Bypass” is automatically select-
ed.
Note
❒ If you place A4, 8
1
/
2
" × 11" or
larger copy paper, hold the
edge of the paper and push
down the paper guide release
lever.
❒ If you do not push down the pa-
per guide release lever, a mis-
feed might occur.
When copying onto custom size
copy paper
Important
❒ To avoid paper misfeeds, you
should specify the size of copy
paper.
A Press the {
{{
{R/#}
}}
} key.
B Make sure “1.Paper Size” is
displayed, and then press the
{
{{
{OK}
}}
} key.
C Press the 0
00
0 or 1
11
1 key until
”Custom Size”is displayed,
and then press the {
{{
{OK}
}}
} key.
ZENY140E
Speed Dial
Pause/
On Hook Dial
Redial
Tone
KirC1a_AE_F_FM.book Page 31 Friday, January 31, 2003 4:54 PM
To Next Page
Loading...
