Ricoh Aficio 1515 - SP5-XXX (Mode)

9 March 2004 SERVICE PROGRAM
5-13
Service
Tables
SP5-XXX (Mode)
5001
All Indicators On
5001 1
Turns on all LEDs. The LCD turns on or off every 3 seconds. Press the reset key to
end this program.
5113*
Optional Counter Type
0:
None
11: MF key card (Increment)
12: MF key card (Decrement)
5113 1 Selects the corresponding key for installed devices such as coin lock.
5120*
Clear-OP Count Remove [
0
=Yes / 1=Standby only / 2=No]
5120 1
Specifies the condition to reset the copy job settings when the key counter is
removed.
• 0 = Yes: The settings are cleared when the counter is removed.
•
1 = Standby only: The settings are cleared when the counter is removed at the
end of a job.
• 2 = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these
setting.
5121*
Count Up Timing [
0
= Feed In / 1 = Exit]
5121 1 Selects the count-up timing.
•
0 = Feed: At each paper feed
• 1= Exit: At each paper exit
5501*
PM Alarm Interval [0 ~ 9999 /
0
/ 0K copies/step]
5501 1 Printout Specifies when the PM alarm occurs.
5801
Memory Clear (basic model only)
5801 2 Engine ☛ 5.1.5
5802
Machine Free Run
5802 1 Conducts machine free run (including the scanner unit). Press “ON” to start; press
“OFF” to stop.
Input Check 5803
☛
5.1.6
Output Check 5804
☛
5.1.7