9 March 2004 SERVICE PROGRAM
5-23
Service
Tables
Fusing Temperature Adjustment
1105*
Adjusts the target fusing temperature. Note that the thermistor is at the center of the
hot roller.
1105 1 Warm Up-Center [140 ~ 180 / 160 / 1°C/step]
1105 3 Standby-Center [140 ~ 160 /
150
/ 1°C/step]
1105 5 Copying-Center [140 ~ 180 / 160 / 1°C/step]
1105 7 Low Level 2-Center [0 ~ 80 /
60
/ 1°C/step]
1105 9 Thick-Center [140 ~ 185 /
165
/ 1°C/step]
1106
Display Fusing
1106 1 Center Displays the fusing temperature.
Fusing Soft Start
DFU
1107*
Adjusts the number of zero-cross cycles of the fusing lamp AC supply needed to
bring the fusing lamp power to 100% while bringing the lamp up to the standby
temperature or while copying. Increase this value if the machine is experiencing
sudden power dropouts.
1107 1 Warm Up Soft Start [0 = 10 cycles / 1 = 20 cycles /
2
= 50 cycles]
1107 2 Other Soft Start [0 = 10 cycles / 1 = 20 cycles /
2
= 50 cycles / 3 = 1 cycle]
1107 3 Soft Stop Setting [0: No / 1: Yes]
1108* Set-Fusing Start [0 = 1s / 1 = 1.5s / 2 = 2s]
1108 1 Specifies the interval for fusing-temperature control.
1109 Nip Band Check
1109 1 Conducts the nip band check (☛ 3.5.7).
1110*
Fan Control Timer [30 ~ 60 /
30
/ 1 s/step]
1110 1
Specifies the fan control time. The fan motor keeps its operating speed for the
specified time before changing the speed or stopping. The fan control timer
prevents the exhaust fan from suddenly stopping. This function protects the copier
from overheating.
1902 Display-AC Freq.
1902 1
Displays the fusing lamp power control frequency (as detected by the zero cross
signal generator). The displayed value is 1/5 the actual frequency: 10 and lower =
50 Hz, 12 and lower = 60 Hz.
1911*
By-pass Envelope [
0
= Disabled / 1= Enabled]
1911 1
The program dedicated to envelope printing runs when you enable this program
(SP1-911-001) and you select “Thick Paper” as the paper type of the by-pass tray
(
$
> System Settings > Tray Paper Settings > Paper Type: Bypass Tray).
To Next Page
Loading...
