SERVICE PROGRAM 9 March 2004
5-40
5844
* USB
Transfer Rate Full Speed /
Auto Change
5844 1*
Sets the speed for USB data transmission.
Full Speed: (12 Mbps fixed)
Auto Change: 480 Mbps/12 Mbps auto adjust
Vendor ID [0x0000~0xFFFF/
0x05CA
/1/step],
DFU
5844 2*
Sets the vendor ID: Initial Setting: 0x05CA Ricoh Company.
Product ID [0x0000~0xFFFF/
0x0403
/1/step],
DFU
5844 3*
Sets the product ID.
Device Release Number [0000~9999/
0100
/1/step],
DFU
5844 4*
Sets the device release number of the BCD (binary coded decimal) display.
Enter as a decimal number. NCS converts the number to hexadecimal number
recognized as the BCD.
Delivery Server Setting
5845
*
Provides items for delivery server settings.
FTP Port No. [1~65535 /
3670
/ 1/step] 5845 1*
Sets the FTP port number used when image files to the Scan Router Server.
IP Address (Primary) Range:
000.000.000.000
~ 255.255.255.255 5845 2*
Use this SP to set the Scan Router Server address. The IP address under the
transfer tab can be referenced by the initial system setting.
Error Display Time [0~999 / 300 / 1/step] 5845 6*
Use this setting to determine the length of time the prompt message is displayed
when a test error occurs during document transfer with the NetFile application and
an external device.
IP Address (Secondary) Range:
000.000.000.000
~ 255.255.255.255 5845 8*
Specifies the IP address assigned to the computer designated to function as the
secondary delivery server of Scan Router. This SP allows only the setting of the IP
address without reference to the DNS setting.
Delivery Server Model [0~4/ 0 / 1/step] 5845 9*
Allows changing the model of the delivery server registered by the I/O device.
0: Unknown
1: SG1 Provided
2: SG1 Package
3: SG2 Provided
4: SG2 Package
Delivery Svr Capability [0~255 / 0 / 1/step]
Bit7 = 1 Comment information exits
Bit6 = 1 Direct specification of mail address possible
Bit5 = 1 Mail RX confirmation setting possible
Bit4 = 1 Address book automatic update function exists
Bit3 = 1 Fax RX delivery function exists
Bit2 = 1 Sender password function exists
Bit1 = 1 Function to link MK-1 user and Sender exists
5845 10*
Bit0 = 1 Sender specification required (if set to 1, Bit6 is set to “0”)
Changes the
capability of
the
registered
that the I/O
device
registered.
To Next Page
Loading...
