9 March 2004 COPIER
1-7
Installation
5. Remove the three scanner lock
pins. (A tag is hanging from each
pin.) To remove: Grasp the base
of the pin [A], turn the pin 90
degrees, and pull it down and out.
6. Remove the tags from the pins.
7. Break each pin off the base [A].
8. Discard the pin part [B].
9. Set each base [A] back into its original hole, turning it 90
°
to lock it into place.
(Be sure to do this for all three pins.)
10. When installing a DF-equipped
model, raise the DF upper guide [C]
and remove the protective paper
[D] at the feed unit. Then lower the
guide.
11. Open the platen cover [E] and
remove the protective paper [F]
covering the exposure glass. Then
close the platen cover.
B046I106.WMF
B046I107.WMF
[E]
[F]
[C]
[D]
[A]
[B]
To Next Page
Loading...
