SERVICE PROGRAM 9 March 2004
5-64
5.1.6 INPUT CHECK (SP5-803)
Conducting Input Check
1. Select SP5-803.
2. Select the number (see the table below) corresponding to the component.
3. Select “Execute.” The copy mode is activated.
4. The sign “01H” or “00H” is displayed (see the table below).
Input Check Table
Num. Sensor/Switch 1h 0h
001 Safety SW Open Closed
003 Right Cover SW Open Closed
005 Tray Cover SW Open Closed
006 Upper Relay S Paper detected Not detected
009 Registration Sensor Paper detected Not detected
010 Exit Sensor Paper detected Not detected
011 Duplex Inverter S Paper detected Not detected
014 By-pass PE S Paper detected Not detected
016 Upper PE S Paper detected Not detected
017 Lower PE S Paper detected Not detected
027 PCU Set Signal Installed Not installed
028 Optional Tray * *
030 Duplex Installed Installed Not installed
032 Main M Lock Locked Not locked
033 Polygon M Lock Locked Not locked
035 Total CO Install Installed Not installed
036 Key CO Install Installed Not installed
037 L-Synchronization Detected Not detected
039 DF-Cover Open S Detected Not detected
040 DF-Original Set S Detected Not detected
041 DF-Registration S Detected Not detected
045 Platen Cover S Open Closed
050 Fan Motor Lock (High speed) Locked (High speed) Not locked
052 Front Cover SW Open Closed
053 HP Sensor Detected Not detected
* Available Paper Feed Unit
00 None
30 1-tray paper feed unit
To Next Page
Loading...
