SERVICE PROGRAM 9 March 2004
5-66
5.1.8 SERIAL NUMBER INPUT (SP5-811-001)
Specifying Characters
SP5-811-001 specifies the serial number. For the basic model (the machine
without the controller box), you use the numeric keypad. For other models (the
machine with the controller box), you use the numeric keypad and the multi-
function panel.
Basic Model
A serial number consists of 11 characters. You can change each character by
pressing one of the first 11 keys on the numeric keypad (
#
,
)
,
*
, ...
+
,
#
,
$
).
For example, when you press the
#
key, the first character of the serial number
changes as follows: 0 → 1 → 2 → ... → 8 → 9 → A → B → ... → X → Y → Z.
When you press the ) key, the second character changes likewise.
You can specify a digit (“0” to “9”) or a capital letter (“A” to “Z”) for the first four
characters of a serial number, and you can specify a digit in the other seven
characters (not capital letters).
Other Models
You use the numeric keypad to type numbers. In addition, you use the multi-
function panel to type other characters. When you press the “ABC” key, the letter
changes as follows: A → B → C. To input the same letter two times, for example
“AA,” you press the “ABC” key, the “Space” key, and the “ABC” key. To switch
between uppercase letters and lowercase letters, press the “Shift” key.
Serial Number and NVRAM
Serial numbers are stored in the NVRAM before shipment and are not cleared by
any program. You must specify a serial number after you replace the NVRAM.
To Next Page
Loading...
