9 March 2004 BIT SWITCHES
3-17
Service
Tables
3.2.2 IFAX SWITCHES
See the IFAX Service Manual.
3.2.3 PRINTER SWITCHES
Printer Switch 00 SP No. 1-103-001
No FUNCTION COMMENTS
0 Page separation mark
0:
Disabled
1:
Enabled
0:
No marks are printed.
1
: If a received page has to be printed out on two
sheets, an asterisk inside square brackets is printed
at the bottom right hand corner of the first sheet,
and a “2” inside a small box is printed at the top right
hand corner of the second sheet. This helps the
user to identify pages that have been split.
1
Repetition of data when the
received page is longer than
the printer paper
0: Disabled
1: Enabled
0: The next page continues from where the previous
page left off.
1: The final few mm of the previous page are
repeated at the top of the next page. The amount of
repeated data depends on printer switch 04, bits 5
and 6.
2
Prints the date and time on
received fax messages
0: Disabled
1: Enabled
This switch is only effective when user parameter 02
- bit 2 (printing the received date and time on
received fax messages) is enabled.
1: The machine prints the received and printed date
and time at the bottom of each received page.
3-7
Not used Do not change the settings.
Printer Switch 01
- Not used (Do not change the settings.)
The table lists the paper sizes and print widths used in the setup protocol.
Available Paper Size Print width used in the Protocol (NSF/DIS)
A4 or 8.5" x 11" 297 mm width
B5 256 mm width
A5 or 8.5" x 5.5" 216 mm width
No paper available (Paper end) 216 mm width
To Next Page
Loading...
