9 March 2004 DEDICATED TRANSMISSION PARAMETERS
3-45
Service
Tables
3.4 DEDICATED TRANSMISSION PARAMETERS
You might see the transmission to a particular destination often fail. In a case like
this, register the destination to the Quick Dial and try changing parameters. This
may solve the problem.
3.4.1 PROGRAMMING PROCEDURE
For the details of the parameters, see the next section.
1. Access the System Switch 00 (SP1-101-001).
2. Change Bit 0 from "0" to "1."
3. Quit the SP mode.
4. Press the " key.
5. Select the menus as follows: System Settings → Key Operator Tools →
Address Book Management
→
Program/Change
6. Select the Quick Dial number.
7. Press the OK key two times.
8. Press the "Dest." key.
9. Select "Fax Settings."
10. When the programmed dial number is displayed, press the start key. Make sure
that the LED of the start key is lit as green.
11. The parameter numbers are displayed (00 ∼ 09). Select the parameter number.
12. Press the OK key.
13. The settings are displayed. Change the setting as necessary.
14. Press the OK key.
15. Press the ! key several times until you quit the User Tools.
16. Access the System Switch 00 (SP1-101-001).
17. Change Bit 0 from "1" to "0."
18. Quit the SP mode.
To Next Page
Loading...
