PAPER TRAY UNIT HEATER 9 March 2004
1-18
18. Pull the relay harness back into
the copier.
19. Attach the ferrite core [A] over the
relay harness.
20. Push the ferrite core back so that
it is over the heater's harness.
21. Wrap the heater's harness once
around the ferrite core [B].
22. Locate the ferrite core at the rear of
the copier [A] behind the rear
clamp.
23. Secure the ferrite core with the
supplied tie wrap [C].
24. Clip off the excess length of the tie wrap [D].
25. Connect the relay harness connector [E] to the large connector at the front
center of the PSU.
26. Screw the ground wire [F] to the PSU bracket with the included grounding
screw.
27. Attach the clamps [G] to the PSU bracket.
28. Attach the heater harness though the clamps.
29. Position the harness so that the front clamp is between the two bindings [H] on
the harness.
30. Fasten the clamps.
B046I521.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[H]
[G]
To Next Page
Loading...
