Transmission Mode
6
1
When your e-mail address is
programmed with the user code
If your e-mail address is pro-
grammed with the user code, you
can select whether the machine
sends transmission by result e-
mail.
A Press [Yes] or [No].
Note
❒ If you select [Yes], a Trans-
mission Result Report is sent
to the programmed e-mail
address after the transmis-
sion so that you can check the
result of transmission.
E
EE
E
Press [OK] twice.
The standby display appears.
Note
❒ To check the settings, press
[
Transmission Mode
].
F
FF
F
Specify a destination, and then
press the {
{{
{Start}
}}
} key.
Note
❒ You can cancel the transmission
setup for User Transmission.
See p.19 “Canceling a Transmis-
sion”.
RussianC3Fax-combine-AE_F_FM.book Page 6 Monday, July 14, 2003 2:36 PM
To Next Page
Loading...
