Appendix
200
11
Limitation
❒ There may be a difference in the size of the image when it is printed at the des-
tination.
❒ If you place an original larger than A3, 11"×17" on the exposure glass, only an
A3, 11"×17" area is scanned.
Note
❒ Even if an original is correctly placed on the exposure glass or in the ADF, a
margin of 3 mm (0.1") around each edge of the original may not be sent.
❒ If the receiver uses paper of a smaller width than the original, the image will
be reduced to fit that paper. See p.74 “Auto Reduce”.
❒ The machine detects paper sizes in the following ways:
• When you place an original in the ADF, an original wider than about 264
mm (10.4") is scanned as A3, 11"×17" size and an original narrower than
about 264 mm (10.4") is scanned as B4 JIS.
An original narrower than about 230 mm (9.1") will be sent as 8
1
/
2
"×11" or
8
1
/
2
"×14" size.
Originals up to 1,200 mm (47.2") in length can be scanned.
• Refer to the table below for sizes the machine can detect when you place
an original on the exposure glass. Because the machine scans non-standard
size documents in a standard size, part of the image may be truncated de-
pending on the length of the document. For details about how to set non-
standard size documents, see p.16 “Setting a Scan Area”, Facsimile Refer-
ence <Basic Features>.
❖
❖❖
❖ Metric Version
❖
❖❖
❖ Inch Version
*1
Normally a length of about 420 mm (16.5") can be scanned; however, it is only possi-
ble to specify a scanning size up to 432 mm (17").
Length
*1
Width
∼
245mm 245
∼
270mm 270
∼
319mm 319
∼
344mm 344mm
∼
∼
245mm not detect-
ed
B5 JIS
L
A4
L
8
1
/
2
"
×
13"
L
8
1
/
2
"
×
14"
L
245
∼
270
mm
B5 JIS
K
not detect-
ed
not detect-
ed
not detect-
ed
B4 JIS
L
270mm
∼
A4
K
not detect-
ed
not detect-
ed
not detect-
ed
A3
L
Length
*1
Width
∼
12.5" 12.5"
∼
13.5" 13.5"
∼
∼
9.6"
8
1
/
2
"
×
11"
L
8
1
/
2
"
×
13"
L
8
1
/
2
"
×
14"
L
9.6"
∼
10.6" 8"
×
10"
K
not detected 10"
×
14"
L
10.6"
∼
8
1
/
2
"
×
11"
K
not detected 11"
×
17"
L
RussianC3Fax-combine-AE_F_FM.book Page 200 Monday, July 14, 2003 2:36 PM