Preparing to Print
36
2
❒ SCSI print using the optional IEEE
1394 interface board is not sup-
ported by Windows 95/98/Me, or
Windows NT 4.0. If the “plug and
play” function starts, click [Cancel]
in the [New Hardware Found] or [De-
vice Driver Wizard] dialog box.
Note
❒ If [Found New Hardware Wizard] ap-
pears every time the computer is
started or the cable is connected
with Windows 2000 or Windows
XP when the printer function that
uses SCSI print is not installed, dis-
able the device. See p.37 “Disa-
bling the Device” for more
information.
❒ If you send data from your compu-
ter when data is being received
from another client computer,
your data will be printed after
completing the print job for the
other client computer.
❒
When the machine is connected to
the computer properly via the 1394
interface, the appearance of the icon
in the printer window changes.
Windows 2000
Important
❒ In Windows 2000, the optional
IEEE 1394 interface board can only
be used with Service Pack 1 or lat-
er. If the Service Pack is not in-
stalled, the connectable number of
devices in an IEEE 1394 bus is only
one, and the client cannot access
the IEEE 1394 interface board with-
out using an account that has Ad-
ministrator permission.
A
AA
A
Connect the machine and compu-
ter using the IEEE 1394 interface
cable.
The [Found New Hardware Wizard] di-
alog box appears.
B
BB
B
Click [Next].
“This wizard will complete the in-
stallation for this Device: Un-
known” appears.
C
CC
C
Select [Optional search locations:],
and then click [Next].
D
DD
D
When “Locate Driver Files” ap-
pears, select the [
Optional search lo-
cations.] check box and the [Specify
a location
] check box, and then
click [Next].
E
EE
E
Hold down the left {
{{
{SHIFT}
}}
} key
and insert the CD-ROM into the
CD-ROM drive.
Keep the left {
{{
{SHIFT}
}}
} key held
down until the computer has fin-
ished accessing the CD-ROM.
If the Auto Run program starts,
click [Cancel], and then click [Exit].
F
FF
F
Click [Browse].
G
GG
G
Select the printer driver you want
to install. Each printer driver is
stored in the following folders:
• PCL 6: \DRIVERS\PCL6\
WIN2K_XP\(Language)\
DISK1
• PCL 5e: \DRIVERS\PCL5E\
WIN2K_XP\(Language)\
DISK1
• RPCS™: \DRIVERS\RPCS\
WIN2K_XP\(Language)\
DISK1
• PostScript 3: \DRIVERS\PS\
WIN2K_XP\(Language)\
DISK1
H
HH
H
Click [Open].
I
II
I
Click [OK].
A printer model selection dialog
box appears.
RussianC3-GB-Pref1-F1_FM.book Page 36 Friday, June 13, 2003 2:16 PM
To Next Page
Loading...
