EasyManua.ls Logo

Ricoh Aficio 2022 - Page 955

Ricoh Aficio 2022
1118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Printing with NetWare
67
5
B To create a new print server,
press the {
{{
{INSERT}
}}
} key, and
then enter a print server name.
Note
If you are using a currently
defined print server, select
one of the print servers
shown in the [Print Server] list.
Important
Use the same name as that
specified in NIB Setup Tool.
(Step
G
-A).
C On the [Print Server Information]
menu, click [Print Server Configu-
ration].
D On the [Print Server Configura-
tion] menu, click [Printer Configu-
ration].
E Select the printer indicated as
"Not Installed".
Important
Use the same number as that
specified as the Remote
Printer No. using NIB Setup
Tool. (Step
G
-D).
F
If you want to change the print-
er name, enter a new name.
Note
The name "Printer x" is as-
signed to the printer. "x"
stands for the number of the
selected printer.
G Click [Remote Parallel, LPT1] as
the printer type.
IRQ, Buffer size, Starting form,
and Queue service mode are au-
tomatically configured.
H Press the {
{{
{ESC}
}}
} key, and then
click [Yes] when the confirma-
tion message appears.
I Press the {
{{
{ESC}
}}
} key to return to
the [Print Server Configuration]
menu.
L
LL
L
Assign print queues to the created
printer as follows:
A On the [Print Server Configura-
tion] menu, click [Queues Serv-
iced By Printer].
B Select the printer created in
step
K
KK
K
.
C
Press the
{
{{
{
INSERT
}
}}
}
key to select
a queue serviced by the printer.
Note
You can select more than one
queue at a time.
D Follow the instructions on
screen to make other necessary
settings.
When you have finished the
above procedure, make sure the
queues are assigned.
M
MM
M
Press the {
{{
{ESC}
}}
} key until the "Ex-
it?" appears, and then click [Yes]
to quit PCONSOLE.
N
NN
N
Start the print server by entering
the following from the NetWare
server's keyboard.
If it is running, restart after quit-
ting.
To quit
CAREE: unload pserver
To start
CAREE: load pserver
print_server_name
Note
If the printer works as config-
ured, "Waiting for job" appears.
NetWare 3.x ends here.

Table of Contents

Related product manuals