Appendix
100
9
Direct printing port
The direct printing port allows print-
ing directly from a computer, con-
nected to the network, to the printer.
Use the "diprint" command to change
direct printing port settings.
❖
❖❖
❖ View settings
The following command displays
the current direct printing port set-
tings:
msh> diprint
Example output:
port 9100 timeout=300(sec)
bidirect off
•“Port” specifies the port
number of the direct printing
port.
• The “bidirect” setting indicates
whether the direct printing port
is bidirectional or not.
❖
❖❖
❖ Setting timeout
You can specify the timeout inter-
val in use when receiving data
from the network.
msh> diprint [30~65535]
Note
❒ The default is 300 seconds.
❒ If 0 is set, timeout is disabled.
❖
❖❖
❖ Bidirectional configuration for the di-
rect printing port
Use this setting to configure wheth-
er the direct printing port is bidirec-
tional or not. The default is “off”.
msh> diprint bidirect {on
| off}|msh> diprint bidi-
rect {on | off}
Note
❒ If you select [on], SmartNet-
Monitor for Client or Standard
TCP/IP on Windows 2000
might not work correctly.
SMB
Use the "smb" command to configure
or delete the NetBEUI settings such as
the computer name or workgroup
name.
msh> smb parameter
Note
❒ You cannot use a computer name
starting with "RNP" or "rnp".
Parameter Settings
comp Your computer name consist-
ing of up to 15 characters
group Workgroup name consisting
of up to 15 characters
comment Comment consisting of up to
31 characters
clear comp Clears the computer name
clear group Clears the Workgroup name
clear com-
ment
Clears comment
To Next Page
Loading...
