Setting Originals
27
2
Setting Originals
Note
❒
Basically the originals should be
aligned to the rear left corner.
However, some copy functions
may produce different results de-
pending on the direction of the
originals. For details, see explana-
tions of each function.
Reference
See
⇒
P.15
“Originals”
.
Setting Originals on the
Exposure Glass
A Lift the platen cover or the docu-
ment feeder.
Note
❒
Be sure to open the platen cover
or the document feeder by more
than 30
°
, otherwise the original
size might not be detected cor-
rectly.
B Set the original face down on the
exposure glass. The original
should be aligned to the rear left
corner.
1: Reference mark
2: Scale
C Lower the platen cover or the doc-
ument feeder.
Setting Originals in the
Document Feeder
Note
❒
The original might become dirty if
it is written with a pencil or similar
tools.
❒
You cannot set a multi-page origi-
nal with pages of different sizes in
the document feeder. If your origi-
nal contains pages of different siz-
es, use the SADF function and set
each page one at a time. Alterna-
tively, set pages one at a time on
the exposure glass.
❒
Do not place any foreign objects on
the document feeder or cover it
with your hand. This could cause
Originals Set in the
document
feeder
Set on the
exposure
glass
To Next Page
Loading...
