DRAFT 2003/11/12
Copying
20
2
❒ When [Press Start Key] is select-
ed in the Copy Start Method,
copying starts when you press
the {
{{
{Start}
}}
} key. See p.86 “Copy
Start Method”.
❒ The number of scanned origi-
nals is displayed in the screen's
top right corner.
-
--
-Interrupting a multiple-sheet
copy job
Press the {
{{
{Clear/Stop}
}}
} key after the
originals have fed in. The machine
stops when the current copy finishes.
Press [Yes] to cancel the copy job;
press [No] to resume the interrupted
copy job.
Auto Start
If you make settings and scan the
originals while the message “
Ready
”
is displayed, your copies will be
made as soon as the warm-up finish-
es.
Copier Auto Reset
The machine automatically returns to
its initial condition when your job is
finished, after a certain period of
time. This function is called ,“Copier
Auto Reset”.
Note
❒ Default settings are applied after
Copier Auto Reset, or after the
{
{{
{Clear Modes}
}}
} key has been
pressed, and are as follows:
*1
Can be changed by Auto Density.
*2
When optional paper roll tray 1 is
installed, it becomes On.
*3
When optional paper roll tray 1 is
installed, it becomes paper roll tray
1. When optional paper roll tray 2
or cut paper tray is installed, it be-
comes Auto.
*4
Can be changed by Ppr.Tray Prior-
ity.
❒ You can change the Copier Auto
Reset time. See p.84 “Copier Auto
Reset”.
❒ In the following cases Copier Auto
Reset will not restore settings to
their default values:
• If there is an original or paper
jam
• When Service Call occurs
• If a cover is open
• If copying was interrupted
• During copying (if the specified
number of copies is not com-
pleted)
• During copying (if there is no
paper in the bypass tray after a
manual copy original was
scanned)
Auto Image Densi-
ty
On
Combined Auto
and Manual Densi-
ty
On
*1
Default image den-
sity
Center
Synchro Cut
Off
*2
Selected paper tray
Bypass Tray
*3
*4
Full size On
To Next Page
Loading...
