Settings You Can Change with User Tools
33
3
Settings You Can Change with User Tools
Reference
To access User Tools, see p.31 “Accessing User Tools (System Settings)”.
General Features
❖
❖❖
❖ Adjust Cut Length
You can specify the cut length when using synchro, preset, or variable cut.
Note
❒ Default
• Metric version: 0.0 mm
From –25 mm to +25 mm (in 1 mm increments)
• Inch version: 0.0 inch
From –1.0 inch to +1.0 inch (in 0.1 inch increments)
❖
❖❖
❖ Fusing Adjustment
You can specify the characteristics of the paper in the paper tray. If the image
on copies is scratched, or the paper wrinkles when using translucent paper,
you can change the setting to get better copies.
You can specify the paper thickness for the bypass tray, paper roll, and cut pa-
per. You can also specify the paper type (plain, translucent, and film) for the
bypass tray or paper roll tray.
Note
❒ Default: 3 (Plain paper or Film), 2 (Translucent paper)
❒ The paper thickness can be set from 1 (Thicker) to 5 (Thinner).
NeptuneC1_GBzen_F_FM_pre.book Page 33 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
