Copier Functions
69
2
To change the stamp position
A Press [Change].
B Select the position, and then press
[OK].
Specifying the first printing page and
start number
If you selected (P1, P2…, -1-,-2-…,
P.1, P.2…, 1, 2…, )
Note
❒ The following explanation uses P1,
P2... as an example. The steps are
the same for other selections.
A Press [Change] on the right side.
B Press [First Printing Page], then en-
ter the original page number from
which to start printing using the
number keys, and then press the
{#} key.
Note
❒ To change the number entered,
press [Clear] or the {Clear/Stop}
key, and then enter a new
number.
C Press [Numbering from/to], enter the
number of the page from which to
start numbering using the
number keys, and then press the
{#} key.
Note
❒ The example below shows the
first printing page as “2”and the
start number as “3”.
D Press [Last Number], enter the
number of the page to stop num-
bering using the number keys,
and then press the {#} key.
Note
❒ If you want to number all pages
to the end, press [to the end].
E When page designation is com-
plete, press [OK].
F Press [OK] 3 times.
GCANPE2J
RuC4_AE_Copy-F_FM_forPaper.book Page 69 Thursday, April 14, 2005 1:21 PM
To Next Page
Loading...
