Ricoh Aficio AP610N - Page 148

Troubleshooting
58
5
HDD Full The maximum HDD area size
for form/font has been exceed-
ed.
Delete the disused form/font types.
The optional Hard Disk Drive
is full. The sample print job or
locked print job to be sent from
the computer is too large to
store.
Delete any unnecessary stored files.
HDD not Installed You cannot print the sample
print and the locked print jobs,
because the optional Hard Disk
Drive is not installed.
Install the Hard Disk Drive.
See “Attaching Hard Disk Drive Type
2600”, Setup Guide.
Hex Dump Mode The printer is in Hex Dump
Mode.
No action required.
Invalid Data
Power Off On
The printer has received irreg-
ular data.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Invalid Password
Try again
The password entered using
the control panel is not correct.
Enter the correct password using the
control panel.
Load Correct
Size Paper
/ Press #
to continue
The paper size setting on the
tray differs from that of actual
paper size in the tray.
Load { paper size } paper of the select-
ed feed direction and paper size into
the tray. Printing will not automati-
cally resume if the paper size and di-
rection setting is incorrect. Make sure
that the paper feed directions set in
the printer driver and on the control
panel are the same. There are two
methods to resume printing.
A Use the control panel to set the cor-
rect paper size and direction of the
paper in tray. Then Press the {# En-
ter} key .
B Press {Form Feed} and select the
tray with the control panel.
Load Paper
or Form Feed
/ Paper Size:
Paper Type:
The paper type and size set-
tings for this tray do not match
the size and type of paper actu-
ally loaded.
Load paper into the tray indicated,
then press the {# Enter} key to resume
printing. Or press {Form Feed} and se-
lect the tray that holds a different type
of paper. To cancel printing, press {Job
Reset}. Then Press the {# Enter} key .
Load Paper:Tray #
or Form Feed
/ Paper Size:
Paper Type:
There is no paper left in this
tray.
#: tray number
Load paper into the tray indicated.
Messages
/Second messages
Description Solution
KirP4GB_Mainte-F5_FM_forPaper.book Page 58 Wednesday, December 8, 2004 6:13 PM