When “Remove Misfeed Duplex Unit” Appears
79
6
F Close the cover of the duplex unit.
Removing misfed paper inside the
duplex unit
A Push down the lever on the right
side of the duplex unit ( ), and
then pull it out until it stops ( ).
B Lift the guide board inside the
duplex unit, and then remove the
misfed paper.
Important
❒ When A5L paper misfeeds,
you might not be able to remove
it by pulling the duplex unit
out. In this case, pull the paper
tray out, and then remove the
paper.
C Align the power cable with the
groove of the left slide of the du-
plex unit, and then insert the du-
plex unit into back of the printer
aligning the rails inside of the
printer until it is connected.
Reference
If the error message appears
again, the misfed paper might
be left in the printer. Confirm
that any torn paper scraps are
not in the inside of the printer.
For more information, see p.73
“When “Remove Misfeed Inter-
nal Path” Appears”.
ZKGY360E
ZKGX320E
ZKGY440E
ZKGX240E
KirP4GB_Mainte-F5_FM_forPaper.book Page 79 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
