Making Printer Settings Using the Control Panel
138
•-3 to 3
For details, see “Adjusting the Image Density”, Maintenance Guide.
❖ Registration
You can adjust the starting position of the printing page.
❖ Prt. Test Sheet
You can print the registration sets sheet.
• Tray 1, Tray 2, Tray 3, Bypass Tray, Duplex.BackSide
❒ Only the installed trays appear on the panel display.
❖ Adjustment
You can select the start position for printing on a page.
• Horiz: Tray 1, Horiz: Tray 2, Horiz: Tray 3, Horiz: Bypass,
Horiz:Dup.Back, Vert.:All Trays, Vert.:Dup.Back
• -4.0 to +4.0
❒ Only the installed trays appear on the panel display.
❖ Curl Prevention
You can control the fuser temperature to prevent paper from curling.
•On
•Off
❒ Default: Off
❒ Use this mode only when paper misfeed occurs frequently during duplex
printing.
❖ HD Format
You can format the hard disk when the optional hard disk is installed.
For details about formatting the hard disk, see “Attaching the Hard Disk
Drive Type 2600”, Setup Guide.
❖ WL.LAN Signal
You can check the signal strength when using wireless LAN.
For details about displaying the signal strength, see p.136 “Displaying the
signal strength”.
To Next Page
Loading...
