Making Printer Settings Using the Control Panel
146
❖ Edge Smoothing
You can set whether edge smoothing is enabled. When it is on, jagged lines
appear more smoothly. Set it to off when the print image contains fine grada-
tion in tone.
•On
•Off
❒ Default: On
❒ If “Toner Saving” is “On”, “Edge Smoothing” is ignored even if it is “On”.
❖ Toner Saving
You can select whether or not Toner Saving is enabled
•Off
•On
❒ Default: Off
❒ If “Toner Saving” is “On”, “Edge Smoothing” is ignored even if it is “On”.
❖ Spool Printing
You can select whether all of the print data is spooled to the hard disk drive
before printing.
•Off
•On
❒ Default: Off
❒ Spooling stores a sent print job temporarily in the printer, and then prints it.
❒ This menu appears only when the optional hard disk is installed.
❖ Letterhead Mode
You can select the letterhead printing mode.
•Off
• Auto Detect
• On (Always)
❒ Default: Off
❖ Bypass Priority
When the different paper size or type is specified from the driver, you can
specify which setting is given priority to, machine setting or command.
• Machine
• Driver/Command
To Next Page
Loading...
