Making Printer Settings Using the Control Panel
157
❒ Default: Portrait
❖ Form Lines
You can specify the number of lines per page between 5 and 128.
❒ Default:
• Metric version: 64
• Inch version: 60
❖ Font Source
You can set the location of the default font.
•Resident
•RAM
•HDD
•SD
❒ Default: Resident
❒ When you select [RAM], you can select only fonts downloaded to the printer
RAM.
❒ When you select [HDD], you can select only fonts downloaded to the op-
tional hard disk.
❖ Font Number
You can specify the ID of the default font you want to use.
• 0 to 50 (Internal)
• 1 to 50 (Download)
❖ Point Size
You can specify the point size you want to use for the default font between 4
and 999.75 in 0.25 increments.
❒ Default: 12.00 points
❒ This setting is effective only for a variable-space font.
❖ Font Pitch
You can specify the number of characters per inch you want to use for the de-
fault font between 0.44 and 99.99 in 0.01 increments.
❒ Default: 10.00 pitch
❒ This setting is effective only for fixed-space fonts.
To Next Page
Loading...
