Attaching 1394 Interface Unit Type 4510
41
3
❒ The removed cover is not used
when installing the 1394 inter-
face unit.
I Attach the 1394 interface unit to
the controller board.
Insert the end of the 1394 interface
unit into the opening ( ), and then
push down until it clicks ( ).
J Fasten the 1394 interface unit to
the controller board.
K Match the controller board to the
top and bottom rail using the “T”
mark, and then slide it into the
printer slowly until it stops.
L Push back the handle of the con-
troller board until it clicks.
ZKGX410E
ZKGX421E
ZKGX430E
ZKGX443E
ZKGX252E
ZKGX380E
KirP4GB_Setup-F4_FM_forPaper.book Page 41 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
