Attaching 802.11b Interface Unit Type F
45
3
I Attach the 802.11b interface unit.
Insert the end of the 802.11b inter-
face unit into the opening ( ), and
then push down until it clicks ( ).
J Fasten the 802.11b Interface Unit
to the controller board with the
two screws.
K Insert the card slowly into the in-
terface unit with the label facing
down and the uneven black anten-
na surface facing up until it stops.
L Match the controller board to the
top and bottom rail using the “T”
mark, and then slide it into the
printer slowly until it stops.
M Push back the handle of the con-
troller board until it clicks.
ZKGX420E
ZKGX431E
ZKGX442E
ZKGX500E
ZKGX251E
ZKGX380E
KirP4GB_Setup-F4_FM_forPaper.book Page 45 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
