Installing Options
46
3
N Fasten the controller board to the
printer with the two screws.
O Attach the antenna cap to the card
with the side that has both cor-
ners of the antenna cap cut out
facing the screws.
P Align the power cable to the left
side groove of the duplex unit,
and then slide the duplex unit in
until it is connected to the printer.
If the duplex unit is not attached,
this step is not necessary.
Note
❒ After finishing installation, you
can check the 802.11b interface
unit is properly installed: Print
the configuration page from the
“List/Test Print” menu. If it is
installed properly, you will see
“IEEE 802.11b” for “Controller
Option”.
❒ If the 802.11b interface unit is
not installed properly, repeat
the procedure from the start. If
you cannot install it properly
even after reinstallation, contact
your sales or service representa-
tive.
❒ You need to make settings with
the control panel before using
the 802.11b interface unit. For
more information, see p.66
“IEEE 802.11b (Wireless LAN)
Configuration”.
Reference
For printing the configuration
page, see p.28 “Test Printing”.
ZKGX273E
ZKGX274E
ZKGX243E
KirP4GB_Setup-F4_FM_forPaper.book Page 46 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
