Installing Options
52
3
E Fasten the two screws (using a
coin, etc.) to fix the hard disk
drive.
Note
❒ After finishing installation, you
can check whether the hard disk
drive is properly installed: Print
the configuration page from the
“List/Test Print” menu. If it is
installed properly, you will see
“Printer Hard Disk Drive” for
“Controller Option”.
❒ If the hard disk drive is not in-
stalled properly, repeat the pro-
cedure from the start. If you
cannot install it properly even
after reinstallation, contact your
sales or service representative.
Reference
For printing the configuration
page, see p.28 “Test Printing”.
ZKGX360E
KirP4GB_Setup-F4_FM_forPaper.book Page 52 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
