Removing Misfed Paper
144
H Check areas B and C of step
E
. Lower the lever in the direction of the
arrows ( ), and then slowly pull out the misfed paper.
I Slowly lift the lever to put it back into place.
J Check area D of step
E
. Lift the lever in the direction of the arrow ( ),
and then slowly pull out the misfed paper.
K Slowly lower the lever to put it back into place.
L Close the front cover of the 2 tray finisher.
If the error message does not disappear even after misfed paper is removed,
detach the 2 tray finisher from the printer to check for misfed paper there.
See p.37 āDetaching the SR960 (2 Tray Finisher)ā for details about how to
detach/reattach the 2 tray finisher from/to the printer.
To Next Page
Loading...
