Replacing Consumables and Maintenance Kit
58
Replacing the Fusing Unit
If “Replace Fusing Unit (Type C)” appears on the display, replace the fusing unit.
A Turn off the power, and then unplug the power cable.
❒ Be sure to wait about an hour to avoid burns.
B If the 2 tray finisher or the booklet finisher is installed, detach it from the
printer.
p.37 “Detaching the SR960 (2 Tray Finisher)”
p.38 “
Detaching the SR950 (Booklet Finisher)”
C If the duplex unit is installed, open the duplex reversal unit.
p.38 “Opening and Closing the Duplex Reversal Unit”
D If the external tray is attached to the printer, raise it in the direction of
the arrow ( ), and then remove it ( ).
• The fusing unit becomes very hot. When installing a new fusing unit, turn off
the printer and wait about an hour. After that, install the new fusing unit. Not
waiting for the unit to cool could result in a burn.
• Touch only the handles, no other parts. The fusing unit gets very hot and
will burn your hands if you touch it.
Replace Fusing
Unit (Type C)
To Next Page
Loading...
