Replacing the Photo Conductor Unit (PCU)
137
6
J
JJ
J
Push the unit into the machine
until it clicks into place.
K
KK
K
Remove the red sheet from the
PCU, and then remove the two
strips of tape.
L
LL
L
Close the machine's right cover.
Note
❒ If you cannot close the ma-
chine's right cover, the PCU is
not installed properly. Slide the
PCU out and push it in again
until it clicks into place.
M
MM
M
Close the front cover.
N
NN
N
If the duplex unit is installed,
close it by pushing up the catch.
Note
❒ Check the "Replace PCU" mes-
sage does not appear on the dis-
play panel.
RussianC3_AEgsg-F_FM.book Page 137 Monday, June 16, 2003 6:35 PM
To Next Page
Loading...
