IF YOUR COPIER DOES NOT OPERATE AS
YOU WANT
Check the followings:
Copier’s condition Action
Nothing happens when the
main switch is turned on.
Check the power cord. Is it properly plugged into the
outlet?
¯
Plug it in firmly.
is lit.
Load paper.
See page 95.
is blinking or lit.
Add toner.
See page 98.
is lit.
Add staples.
If you use the 20-bin sorter stapler,
see page 99.
If you use the 10-bin sorter stapler,
see page 100.
is lit.
Remove misfed paper.
See page 101.
Staples do not come out at all.
After loading a new staple cartridge, staples might not
be ejected the first few times you try to use the stapler.
There are jammed staples in the stapler. Remove the
jammed staples.
If you use the 20-bin sorter stapler,
see page 105.
If you use the 10-bin sorter stapler,
see page 106.
A few sheets might not be stapled. To correct this, try
turning over the paper stack in the 250-sheet, 500-
sheet, or large capacity tray. If there is no improvement,
change to copy paper with less curl.
is lit.
Your machine is in the Energy Saver or Auto Off
condition.
¯
Press any key except the
Start
key to return to the
ready condition.
f-eu-6
IF YOUR COPIER DOES NOT OPERATE AS YOU WANT
90
To Next Page
Loading...
