Copier’s condition Action
C code
is displayed on the
copy counter.
C1
Close the copier’s front cover.
C2
Close the exit cover of the copier.
C3
Close the side cover of the optional paper tray
unit.
C4
Close the cover of the large capacity tray.
C5
Close the cover of the optional 20-bin sorter
stapler, or set the sorter stapler correctly.
Close the cover of the optional 10-bin sorter
stapler, or set the sorter stapler correctly.
Close the cover of the optional 20-bin sorter.
C6
Close the cover of the optional document feeder.
C7
Close the copier’s side cover or large capacity
tray.
U code
is displayed on the
copy counter.
U2
The copier is set for user codes. Enter your user
code (3 digits).
Insert the optional key counter.
Insert the optional key card.
U6
Set the fusing unit correctly.
See page 4 for
the position of the fusing unit.
U7
Set the unit for two-sided copying correctly.
See page 4 for the position of the unit.
E code
is displayed on the copy
counter.
Turn the main switch off, wait a few seconds,
and then turn it on. If the E code appears again,
call your service representative and tell which
code is on. Check the code as follows:
ex.)
E 1 0 1
By pressing the
Decimal Point
key, this code is displayed.
This code is displayed first.
f-eu-6
IF YOUR COPIER DOES NOT OPERATE AS YOU WANT
91
To Next Page
Loading...
