6
❖ Host Interface
❖ PCL Menu
This menu can be selected only when the PCL unit is installed.
Edge to Edge Print You can select whether or not to print on the entire
sheet.
Default Printer Language You can set the default printer language if the machine
cannot find the printer language automatically.
Tray Switching You can set to switch the paper tray.
Menu Description
I/O Buffer You can set the size of the I/O Buffer. Normally it is
not necessary to change this setting.
I/O Timeout You can set how many seconds the machine should
wait before ending a print job. If data from another
port usually arrives in the middle of a print job, you
should increase this timeout period.
Menu Description
Orientation You can set the page orientation.
Form Lines You can set the number of lines per page.
Font Source You can set the storage location of the default font.
Font Number You can set the ID of the default font you want to use.
Point Size You can set the point size you want to use for the se-
lected font.
Font Pitch You can set the number of characters per inch for the
selected font.
Symbol Set You can specify the set of print characters for the se-
lected font. The available options are as follows:
Courier Font You can select a courier font type.
Extend A4 Width You can extend the printing area width when printing
on A4 sheet with PCL.
Append CR to LF When set to On, a carriage return will follow each line
feed: CR=CR, LF=CR−LF, FF=CR−FF.
Resolution You can set the print resolution in dots per inch.
Menu Description
To Next Page
Loading...
