• Specify the paper type and thickness under Paper Type: Tray 1 in User Tools in advance. For the
paper type, select [Envelope]. Specify the paper thickness depending on the thickness of the
envelopes. For details, see “System Settings”, Network and System Settings Reference.
•
Before loading self-adhesive envelopes, be sure to fan them thoroughly. This will prevent them
sticking together. If fanning does not prevent them sticking together, load them one by one. Note
that some types of envelope cannot be used with this machine.
• For the procedure for loading envelopes in tray 1, see “Envelopes”, About This Machine.
• For details about supported envelope types, see “Envelopes”, About This Machine.
• Some kinds of envelopes might cause misfeeds or wrinkle. If this happens, push down the envelope
lever of the fusing unit.
• The Duplex function cannot be used with envelopes. If [1 Sided
2 Sided] is selected, cancel the
setting.
Envelope orientation
When loading envelopes in the landscape ( ) orientation, set them print side up with their flaps
closed and pointing toward the front of the machine.
When loading envelopes in the portrait ( ) orientation, set them print side up with their flaps open
and pointing away from the paper feed direction.
BZK067
Envelope
orientation
Original
orientation
Landscape
orientation
Portrait
orientation
The illustration shows the orientation of copy envelopes loaded in tray 1.
Copying from Tray 1
41
To Next Page
Loading...
