Using a Printer Server
20
1
• Job Timeout: When the interface board is used as a NetWare remote print-
er, the printer cannot detect when a print job ends. Therefore, the printer
terminates printing when a certain period of time has elapsed since it last
received print data (i.e., when it has not received print data for a certain pe-
riod of time). Specify here this period of time (3 to 255 seconds). The initial
value is 15 (seconds).
• Frame Type: Select the frame type from the drop-down menu.
• Print Server Protocol: Select the protocol for NetWare from the drop-down
menu.
• NCP Delivery Protocol: Select the protocol for NCP delivery.
H Confirm the settings, and then click [OK].
Configuration is now complete. Wait several before restarting Web Image
Monitor.
I Click [Logout].
Note
❒ To check the configuration is correct, enter the following from the com-
mand prompt:
F:> USERLIST
❒ If the printer works as configured, the name of the print server appears as
a connected user.
❒ If you cannot identify the printer you want to configure, check the printer
name against the configuration page printed from the printer. For details
about printing a configuration page, see Printer Reference.
❒ If no printer names appear in the list, match the frame types of IPX/SPXs
for the computer and printer. Use the [Network] dialog box of Windows to
change the frame type of the computer.
Setting Up as a Print Server (NetWare 4.x, 5 / 5.1, 6 / 6.5)
Follow the procedure below to connect the machine as a print server using Net-
Ware 4.x, NetWare 5 / 5.1, or NetWare 6 / 6.5.
Important
❒ When using the printer as a print server in NetWare 4.x, NetWare 5 / 5.1, or
NetWare 6 / 6.5, set it to the NDS mode.
❒
When using NetWare 5 / 5.1 or NetWare 6 / 6.5, set the printer as a print server.
A Log on to the file server as an administrator or administrator equivalent.
B Start NIB Setup Tool from the [Start] menu.
C Click [Wizard], and then click [OK].
To Next Page
Loading...
