Remote Maintenance by telnet
59
2
❒ IPv6 mask ranges between 1 - 128 can be selected.
❒ Up to five access ranges can be specified. The entry is invalid if the target
number is omitted.
❒ You cannot send print jobs, or access Web Image Monitor and diprint from a
restricted IP address.
appletalk
Use the “appletalk” command to view and configure appletalk parameters.
❖ View settings
msh> appletalk
• [2] means "active" and [0] means "inactive".
• The default is [2].
❖ Changing PAP timeout configuration
msh> appletalk ptimeout value > 0
• Timeout value becomes effective.
msh> appletalk ptimeout value = 0
• Timeout value becomes ineffective.
authfree
Use the “msh> set bonjour” command to display and configure authentication
exclusion control settings.
❖ View Settings
msh> authfree
If print job authentication exclusion is not set, authentication exclusion con-
trol cannot be displayed.
❖ IPv4 address settings
msh> authfree "ID" range_addr1 range_addr2
❖ IPv6 address settings
msh> authfree "ID" range6_addr1 range6_addr2
❖ IPv6 address mask settings
msh> authfree "ID" mask6_addr1 masklen
❖ Parallel/USB settings
msh> authfree [parallel|usb] [on|off]
To enable authfree, set to "on". To disable authfree, set to "off".
Always specify the interface.
To Next Page
Loading...
