Remote Maintenance by telnet
81
2
❖ sysContact setting
msh> snmp contact
❖ Deleting sysContact
msh> snmp clear contact
❖ SNMP v1v2 function configuration
msh> snmp v1v2 {on|off}
• Specify "on" to enable, and "off" to disable.
❖ SNMP v3 function configuration
msh> snmp v3 {on|off}
• Specify "on" to enable, and "off" to disable.
❖ SNMP TRAP configuration
msh> snmp trap {v1|v2|v3} {on|off}
• Specify "on" to enable, and "off" to disable.
❖ Remote Configuration Authorization configuration
msh> snmp remote {on|off}
• Specify "on" to enable, and "off" to disable the SNMP v1v2 setting.
❖ SNMP v3 TRAP configuration display
msh> snmp v3trap
msh> snmp v3trap {1-5}
• If a number from 1-5 is entered, settings are displayed for that number on-
ly.
❖ Configuring a sending address for SNMP v3 TRAP
msh> snmp v3trap {1-5} {ipv4|ipv6|ipx} “address”
❖ Configuring a sending protocol for SNMP v3 TRAP
msh> snmp v3trap {1-5} active {ipv4|ipv6|ipx} {on|off}
❖ Configuring a user account for SNMP v3 TRAP
msh> snmp v3trap {1-5} account “account_name”
• Enter an account name using up to 32 alphanumeric characters.
❖ Deleting an SNMP v3 TRAP user account
msh> snmp v3trap {1-5} clear account
❖ Configuring an SNMP v3 encryption algorithm
msh> snmp v3auth {md5|sha1}
To Next Page
Loading...
