Ricoh Aficio MP 2500 - Programming an End Receiver

Forwarding
93
4
Programming an End Receiver
Important
❒ One end receiver can be registered for each special sender. To register two or
more end receivers, use group destination. Up to 100 destinations can be
specified in a group. However, when adding a group to another group, a
maximum of 150 destinations can be specified in a group.
A Select [Fax Features] using {U} or {T}, and then press the {OK} key.
B Select [Administrator Tools] using {U} or {T}, and then press the {OK} key.
C Select [Forwarding] using {U} or {T}, and then press the {OK} key.
D Select [On] using {U} or {T}, and then press the {OK} key.
To cancel forwarding, press [Off] and proceed to step
F
.
E Search and select a receiver using the Quick Dial keys or [], and
then press the {OK} key.
If you make a mistake, press the {Clear/Stop} key, and then enter again.