System Settings
12
2
❖ Output:Copier (copier)
You can specify a tray to which documents are delivered.
1. Internal Tray
2. Upper Internal Tray
3. Finisher Shift Tray
The default setting is Internal Tray.
If you set [Paper Type: Bypass Tray] to [OHP], paper loaded in the bypass tray
cannot be fed to the Finisher Shift Tray.
If you select a paper size, paper type, or paper tray not supported by the Up-
per Internal Tray or Finisher Shift Tray, paper is output to the Internal Tray.
❖ Output:Printer (printer)
You can specify a tray to which documents are delivered.
The default setting is Upper Internal Tray.
The output trays set on the printer driver have priority over the output tray
specified above.
❖ Display Contrast
You can adjust the brightness of the display.
The default setting is “4” (the halfway/medium setting).
❖ Key Repeat
You can select whether or not to use the key repeat function.
The default setting is On.
❖ Measurement Unit
You can switch the measurement between “mm” and “inch”.
The default setting is mm (Metric version)/inch (Inch version).
Reference
p.4 “Accessing User Tools”
AYN001S
To Next Page
Loading...
