Placing Originals
17
1
D Enter the horizontal size of the original (Horiz.) with the number keys, and
then press the {OK} key.
1 Vertical size
2 Horizontal size
E Enter the vertical size of the original (Vert.) with the number keys, and then
press the {OK} key.
The “
Programmed” message appears.
When the custom size originals settings are registered, appears
on the top of the copy display.
Note
❒ This function is not available in Auto Paper Select mode.
❒ If you make a mistake in step
D
or
E
, press the {Clear/Stop} key, and then
enter the value again.
❒ To cancel the size you have set, press the {Clear Modes} key.
ARB009S
To Next Page
Loading...
